Extrait de : Le Petit Journal Militaire, Maritime, n°30 pp467-468 Colonial
Résumé : Article 2 p. 1 gravure, 3 photos
Siècle(s) traité(s) : 20
Droits : Domaine public
Provenance : ORkidé|Fonds privé Pierre Rostan
Permalien : http://www.manioc.org/patrimon/ORK12168
ORK12168

Éditeur(s) : HAL CCSD Mineralogical Society of America
Résumé : International audience
The effect of trace concentrations of Ti on the rate and mechanism of hydrogen diffusion in pure forsterite was investigated experimentally. Forsterite doped with 350–400 ppm Ti (predominantly octahedral Ti3+, minor tetrahedral Ti4+) was prepared by diffusing Ti into pure synthetic forsterite at high temperature (1500 °C), very low oxygen fugacity (~QFM-5) at atmospheric pressure. The Ti-doped forsterite was then diffusively hydroxylated in a piston-cylinder apparatus at much lower temperatures (650–1000 °C) and higher oxygen fugacities, at 1.5–2.5 GPa, with chemical activities buffered by forsterite-enstatite or forsterite-periclase and partial pressure of H2O equal to total pressure. This produced hydrogen concentration-distance profiles of several hundred micrometers in length. Diffusion of hydrogen through the Ti-doped forsterite, even at very high Embedded Image , does not lead to redox re-equilibration of the high Ti3+/ΣTi ratio set during the synthesis of the starting material at extremely reducing conditions—the metastable point defects are partially preserved.Three main hydroxylated point defects are observed; hydroxyl is associated with Ti4+ (titano-clinohumite point defects), Ti3+ (and possibly other trivalent cations), and M-site vacancies. Concentration-distance profiles represent an interplay between diffusion and reaction (i.e., site rearrangement) to form the observed point defects. In all experiments, the concentration-distance profiles of the hydroxylated Ti defects coincide with the concentration-distance profiles of the M-site vacancy substitution, with the same crystallographic anisotropy. This suggests that the macroscopic movement of hydrogen through the crystal is due to one diffusion mechanism (the diffusion of hydroxylated M-site vacancies). The net H diffusion coefficient [logD(ΣH)], between 650–1000 °C, is Embedded Image where the values of logD0(ΣH) parallel to [100] and [001] directions are −3.0 ± 0.4 and −2.2 ± 0.4, respectively; diffusion is therefore around one order of magnitude faster along the c axis than along the a axis. The diffusion of hydrogen is slightly faster in Ti-doped forsterite than in pure forsterite. There is no effect of chemical activity or oxygen fugacity on the rate of diffusion. Hydrogen diffusion profiles represent a complex interplay between the movement of H through the crystal lattice and point-defect reactions to maintain charge balance.
ISSN: 0003-004X

hal-01467402
https://hal.archives-ouvertes.fr/hal-01467402
DOI : 10.2138/am-2016-55681571

Éditeur(s) : HAL CCSD Oxford University Press (OUP)
Résumé : International audience
The diffusion of titanium along with Ni, Co and Mn in pure synthetic forsterite has been studied as a function of temperature, oxygen fugacity, crystallographic orientation and chemical potentials in the four-component system MgO–SiO2–TiO2–TiO1·5. In over 100 different experimental conditions, no Ti diffusion profiles with the classical shape of the error function were observed. Instead, the profiles vary between ‘stepped’ at high fO2 (probably owing to diffusion on octahedral sites and trapping in tetrahedral sites), to hockey-stick shapes at low fO2 owing to concentration-dependent diffusion. The profile shapes vary systematically between these end-members according to oxygen fugacity. These profile shapes are also reproduced in experiments using natural San Carlos olivine. The change in profile shape is interpreted to be a function of valence-state change from Ti4+ to Ti3+, shown by a sigmoidal log fO2–diffusivity relationship. To distinguish between Ti4+ and Ti3+ in forsterite, a diffusion profile was also investigated using ‘hydroxylation spectroscopy’ whereby a crystal from a diffusion experiment was hydroxylated by annealing in an H2O-rich fluid at moderate pressure and temperature. The point defects associated with the added structural OH were then determined by infrared spectroscopy, providing evidence for the presence of Ti4+ and Ti3+ at intermediate oxygen fugacity. The transition from Ti4+ to Ti3+ occurs at considerably higher fO2 in these diffusion experiments than in equilibrium experiments in similar systems. Titanium diffusion, qualified using a mobility parameter (M), is fastest along the c-axis, at high activity of silica, low oxygen fugacity and high temperature. The rate of Ti diffusion is broadly similar to those of Mn, Ni and Co, and closer to published rates of Mg self-diffusion in olivine than Si self-diffusion. The observed Ti3+ and Ti4+ diffusion occurs on the M-sites. From statistical examination of the large Mn, Ni and Co diffusivity dataset, we determine that there is a 102/3 dependence of diffusion on aSiO2; the cations diffuse more rapidly at high aSiO2. In addition, diffusivity has a 10–1/8 dependence on fO2, suggested to be the result of increased concentration of loosely bound Ti3+–vacancy pairs, which enhance the mobility of other cations. This behaviour is likely to be present in natural systems where trivalent (e.g. Fe3+, Al3+, Cr3+) and divalent cations diffuse together. Consideration should be given to diffusive interference by highly charged, fast-moving cations when extracting time scales from frozen diffusion profiles.
ISSN: 0022-3530

hal-01531344
https://hal.archives-ouvertes.fr/hal-01531344
DOI : 10.1093/petrology/egw067

Date de création : 1931-01-01

Éditeur(s) : Paris : Payot
Résumé : Bibliothèque historique
Siècle(s) traité(s) : 19
Droits : Domaine public
Provenance : Ville de Pointe-à-Pitre. Réseau des bibliothèques
Permalien : http://www.manioc.org/patrimon/PAP11046
PAP11046